Follow

Brother QL-820NWB Printer: Install DK-2251 Badge Labels

To change or install a new DK-2251 label roll:

  1.  To start, make sure that the printer is completely turned Off.
    Holding the printer on the front, firmly lift the DK Roll Compartment Cover to open.

    Open the cover
     
  2. Now place the DK-2251 Roll into the Roll Spool Guide:
    • Make sure that the Roll Spool Arm is inserted securely in the Roll Spool Guide.
    • Make sure the Stabilizer(1) slides into the designated notch in the printer.

      Place the DK Roll

  3. How to thread the DK Roll through to the printer feed:
    • Align the edge of the DK Roll with the edge of the Label Output Slot in the compartment of the printer.
    • Then insert the end of the first label into the slot inside the compartment.
    • Push the label through to the Label Output Slot until the end reaches the mark (see below).

      Thread the DK Roll

  4. Now you can close the DK Roll Compartment Cover- make sure it is securely closed.
    When you press the Power Power button Button to turn the printer On, the end of the DK Roll will align automatically.

    Close the cover

    Image result for paper pencil iconNOTE: Do not leave any printed labels in the printer. Doing so will cause the labels to jam.

 

To remove a label roll:

  1. To start, be sure that the printer is turned Off.
    Holding the printer on the front, firmly lift the DK Roll Compartment Cover to open.              
  2. Grab the label roll by the top on the spool arms and pull the DK Roll up and out.
     
  3. Now you can close the DK Roll Compartment Cover- make sure it is securely closed.

 

 

 

Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request
Powered by Zendesk